Buzz Bee Shell Modification

1,035

2

2

Your in the heat of battle, your about to take the killing shot but you slip and fall on one of your shells! There's a few simple modifications that you can do to shells to help prevent this.

Step 1: Tools N' Stuff

A pair of tough scissors, a pair of pliers, a Buzz Bee shell, any Buzz Bee blaster that uses shells, and some tape.

Step 2: Step 1

Take your scissors and chop the top off of the shell's dart peg.

Step 3: Step 2

Now you stick your pliers into the shell and wrench as much of the dart peg, if needed you can use scissors for this step.

Step 4: Step 3

Now take your tape and put it around the shell like in the picture.
This mod makes it so the shells don't fly out of the blaster when you reload. ( See pictures 4, 5 , and 6. )

Step 5: Finished!!!

Now go out and have fun with your new shells! By the way, I would only use these in any Buzz Bee double shot variants. Thanks for reading my first Instructable!

Share

    Recommendations

    • Make it Glow Contest 2018

      Make it Glow Contest 2018
    • PCB Contest

      PCB Contest
    • Puzzle Challenge

      Puzzle Challenge

    2 Discussions

    0
    None
    JackDC2000

    4 years ago

    This is neat! I don't have any buzz bee blasters, but I have a friend who had one, and he lost all of the shells. Bet he would have wanted to know this!