CAD Salt & Pepper Shakers

This was another project I did using Pro desktop. This is not the whole project but the Pro desktop images. Pro desktop is really useful, other programs like google sketch up are really useful and free!!!!
The kind of look like Rockets....Pretty cool....Space salt......Salty.......

The Shakers consist of three Parts:

The Base: A flat base for support that curves up to meet the top. The base has a screw part where the top will screw on. to fill the top is taken off.

The Wings: The wings are mostly there to look cool and different from normal salt shakers. they act as a little bit of a support just in case the shaker is knocked over. 

The top: Located at the top of the top is the letter P or S, S for Salt and P for Pepper. The top is flat with a single 3mm hole in the centre for the condiment to pass through. the top much like the bottom curves down to meet the bottom with a thread which screws onto the base. 


Improvements: The top should be smaller and the base bigger, this would allow more salt or pepper to be put into the shaker.
                         There should be four wings so that it is supported on all sides. For Design purposes i should have put an exhaust    onto the bottom to make it look more like a rocket, but the simplistic look looks good.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Make It Real Challenge

Participated in the
Make It Real Challenge

Be the First to Share

    Recommendations

    • Home Decor Contest

      Home Decor Contest
    • Furniture Contest

      Furniture Contest
    • Reuse Contest

      Reuse Contest

    Discussions