Camper R6

7,236

92

4

Introduction: Camper R6

Good day. I definitely did not take enough photos for this to be a step by step instruction.
Camper R6 began it life as the swapping of a Yamaha R6 for a camper trailer tent top. Thus the need to build a trailer for it to fit on let the fun begin.
Chassis is 75 by 50 by 3mm RHS side and front rails.
Inner frame 50 by 50 by 3mm RHS.
Draw bar is 100 b y 50 by 3mm RHS.
Axle is a 2000kg rated 10 inch electric brake on 9 leaf springs.
Wheels are from a Mitsubishi Triton.
Two steady legs at the rear.
Jockey wheel at the front.
3000kg weld on treg style hitch.
Floor, sides and guards are all 1.6mm flat plate.
90 Litter water tank.
Two Jerry can holders.
One 9kg gas cylinder holder.
Sink to cut up for tail gate kitchen.
This entire trailer is built around the dimensions of the tent; the body is fully welded with two access hatches in the front section of the box a lift up gas strut assisted top and a tail gate with a sink and small bench.
Still to finish, rail for motorcycle on A Frame and stone guard.

But for now it is summer and time to go camping

Workshop Contest

Participated in the
Workshop Contest

Instructables Outdoor Projects Contest

Participated in the
Instructables Outdoor Projects Contest

Be the First to Share

    Recommendations

    • Lighting Challenge

      Lighting Challenge
    • Metalworking Contest

      Metalworking Contest
    • Puzzles Speed Challenge

      Puzzles Speed Challenge

    4 Discussions

    0
    Lorddrake
    Lorddrake

    5 years ago on Introduction

    what is the purpose of the open areas ahead of and behind the wheels? is there a reason these areas weren't enclosed to make additional storage spaces?

    0
    kretzlord
    kretzlord

    6 years ago on Introduction

    I would love to see some steps on this! I love the idea here and have thought of it in the context of a yurt, but i love what you've done

    0
    mick2653
    mick2653

    Reply 6 years ago on Introduction

    Sorry that I did not take more photos so I am unable to do a step by step. I Did not think that I would be puting it on here while i was building it.

    0
    kretzlord
    kretzlord

    Reply 6 years ago on Introduction

    I know how that goes, most of my projects are un-documented and thusly not on here. Good building!