Cardboard Box Transformation

Introduction: Combine a (used) from corrugated cardboard box with new modern technology into a product that permanent / long can innovate and get off the gadget atmosphere .

Step 1: Make Side Panels Laptop Holder

Out of the box , we can push out all pieces / cutting.

We first cut the frame of the side pannel .

We then cut out of a slot perpendicular to the angular points at each time one half of the distance.

We do this 2 times in total!

Step 2: Make Back Laptop Holder

Out of the box , we can push out all pieces / cutting.

We first cut the frame of the back pannel of the laptop holder.

We then cut out of a slot perpendicular to the angular points at each time one half of the distance.

Step 3: Making Front Laptop Holder

Out of the box , we can push out all pieces / cutting.

We first cut the frame of the front pannel of the laptop holder.

We then cut out of a slot perpendicular to the angular points at each time one half of the distance.

Step 4: Assembly Panels

We then slide the four pieces into each other in the right place .

Step 5: Ready to Use

The laptop holder is now finished and ready for use. enjoy it!

Step 6: Flatpack Form/Product in Use

By its flatpack form you can always take the laptop holder efficiently.

Down the laptop I have not put a cardboard so the laptop can still fully ventilate the bottom.