Cardboard Plasma Cutter

Introduction: Cardboard Plasma Cutter

Once again, i have made a prop from a video game i've never played. I like dead space. I just like the concept. The whole sci fi genre is by far my favorite a side from action and fantasy.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Trace/draw

Draw out the front blaster part. The thing that looks like two half circles on a rectangle. Make it about four inches tall. Trace three of those after you have cut the first. Cut two lenghts of cardboard about 8 inches long. Cut a trigger type thing (see picture) also four inches long.

Step 2: Glue

Glue the blaster and two lenghts of card board together. And trigger guard on the opposite end. Use two cardboard lengths to seperate each blaster part from each other. For strength, you can use more lengths of cardboard on the side like in the picture.

Step 3: Finish!

Color if you choose, but other than that, your done!! Thanks and feel free to send suggestions for other projects.

Be the First to Share

    Recommendations

    • Fandom Contest

      Fandom Contest
    • Jewelry Challenge

      Jewelry Challenge
    • Backyard Contest

      Backyard Contest

    3 Discussions

    0
    beantean
    beantean

    5 years ago

    My bad! I suppose I ought to make the title a little more specific eh?

    0
    HammE
    HammE

    6 years ago on Introduction

    The title made me think you made a plasma cutter prop for metal cutting!! I know a lot about welding and cutting (more on welding) so tat's what made me think of that.

    0
    HammE
    HammE

    6 years ago on Introduction

    The title made me think you made a plasma cutter prop for metal cutting!! I know a lot about welding and cutting (more on welding) so tat's what made me think of that.