Introduction: Cellphone Travel Cable Organizer
This is a small box where you can store your cell phones
- wall charger
- car charger
- charging cable
- ear buds
It also has a nifty spot to prop up your phone
I printed on an ultimaker2. But most printers should work. I tried adding a latch but that did not work out so well. But the case is very nice with out the latch.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Download
You can download the Fusion 360 project from http://a360.co/2v6ar8J
Step 2: Print Box
Go into fusion360. Open the project. select Print the box part of project
Step 3: Print Lid
print lid part of fusion 360 project
Step 4: Assemble
The lid slids into the box and there is storage for all your cell phone gear