I've got another tutorial to share :)
Cut 1 x 14cm (5.5 inches) 0.8mm (20ga) wire. With your round nose pliers grip the wire at the center. Bend both wires crossing each other to make a loop.
Make the 2nd loop, wrap the left wire onto the round nose pliers by bring the extended wire in clockwise direction.
Then slide in your 6mm round bead. Using your thumb and point finger, carefully wrap the wire onto the bead going inward or counter-clockwise direction.
Make the 3rd loop, wrap the wire onto the round nose pliers in counter-clockwise direction. Wrap the bead again, but this time wrapping in clockwise direction.
Attach a jump ring on each loop then hook the 2 jump rings into another jump ring together with your ear wire.
Make a dangle using ahead pin. Slide the bead and make a loop with the excess wire. Then attach a jump ring and hook it up into the 1st loop.