Christmas Ornament @ TechShop

Introduction: Christmas Ornament @ TechShop

Christmas ornament made using laser cutter at TechShop.

piece of ClipArt or image
2.5" x 3" x 1/4" Acrylic or similar (I used a piece of scrap)
6-8" piece of string or ribbon

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Plan It Out

Choose your clipart or image.

Start up laser cutter.

Import your image to Adobe Illustrator or CorelDraw.

Scale up or down to fit your piece or Acrylic.

Add an ellipse around the image and a hole at the top. Both need to be cut lines.

Step 2: Cut It Out

'Print' your picture to the laser cutter.

remove the protective paper after the laser cutting.

Step 3: Finishing Touches

Feed the string through the new hole at the top and tie a knot.

Display or gift and Enjoy!

Holiday Contest

Participated in the
Holiday Contest

Be the First to Share


    • Toys and Games Challenge

      Toys and Games Challenge
    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge