Clip Fed K'nex Gun KN-5 SMG

214

8

Intro: Clip Fed K'nex Gun KN-5 SMG

First shot at a clip fed gun. A little sketchy, but it works. (Last pic secondary handle)

Share

    Recommendations

    • Furniture Contest 2018

      Furniture Contest 2018
    • Fix It! Contest

      Fix It! Contest
    • Halloween Contest 2018

      Halloween Contest 2018

    8 Discussions

    0
    None

    It's okay. Though, as The Racker said, you should move the trigger back.
    Also, put some large rubberbands on the yellow connector of the pin, otherwise, you're going to break it (Which I see that it already happened)
    The handle could use some filling in too.

    Oh, and this gun is magazine fed, not clip fed ;)

    0
    None
    Ghostmij17

    5 years ago

    I'm on the iOS app and I'm too lazy to get on my computer. I can't find a reply button on the app. And that makes sense, thanks. I'll see about moving it back a little.

    2 replies
    0
    None
    JonnyBGoodGhostmij17

    Reply 5 years ago on Introduction

    Use the internet version instead on your phone. That version allows you to reply.

    Anyway, the gun looks pretty good. I think the handle just needs some more filling in.

    0
    None
    Ghostmij17

    5 years ago

    Thx. And what will moving the trigger back do? Also, I've never heard the term trigger block, but I'd assume it's the part that actually comes in contact with the firing pin (correct me if I'm wrong).

    1 reply
    0
    None
    TheRackerGhostmij17

    Reply 5 years ago on Introduction

    Use the reply button. And it gives the ramrod more time to accelerate, so it hits the round harder and faster.

    0
    None
    TheRacker

    5 years ago on Introduction

    Make the trigger block farther back. Like way farther back. But I like the mag design, I haven't seen anything like it done before.