Cobra Weave Key Fob (Jumbo)

4,016

20

3

Introduction: Cobra Weave Key Fob (Jumbo)


Followed ible from Tevers94:
https://www.instructables.com/id/Corbra-Weave-Key-Fob/

Made mine jumbo-sized though. Probably to be used as a lanyard for a tool.

Did another smaller one for realistic key use.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Sculpting Challenge

      Sculpting Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • 3D Printed Contest

      3D Printed Contest

    3 Discussions

    0
    Jerry E
    Jerry E

    8 years ago on Introduction

    I am keeping my options open on what to do with the tassle ends on the large fob. I do not want to cut them off flush, but I am not sure of the best technique to finish it off. Some kind of beads?

    0
    seanpa
    seanpa

    Reply 7 years ago on Introduction

    You may just want to finish each end with a Celtic button knot. Although they can be a bit bulky, they add a finished touch. Leave enough paracord at the end to make it dangle a bit and then add the knots.

    0
    Jerry E
    Jerry E

    Reply 7 years ago on Introduction

    Thanks. Good call! I have practiced the Celtic button knot, but I did not think of it for this project. I'll give it a try.