I had a Flash drive that I took the case off, and i got a little tired of the exposed circuit board, so I decided to make this...
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Materials and Tools
post-it page markers
clear cellophane tape
USB flash drive
Hot glue gun
Step 2: Laying Down the Markers
Lay two across and overlap it so it doesn't go over the side lay them down to where you plug it in.
Step 3: Repeat
repeat to the other side
Step 4: Cutting
cut off the excess that obstructs you from plugging it into the computer.
Step 5: Tape It
now to make it more durable and give it a nice shine add some transparent tape on it.
Step 6: Finishing Up!
now the stickiness of the tabs are not enough to hold it on the flash drive so add some hot glue to it so it can stick more.
Participated in the