This is an instructable which will show you how to make a ship that crashed into a rock
1-Mini cleaning sponges
2-Lots of cardboard
5-Small tip and Large tip black markers
6-Paper tape(On which you can paint)
If you like it please take a minute and vote for it -->>
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Making the Base
Take 6 sponges and join them using a glue gun
Then take a scissors and trim the edges off to make it into a similar shape to the picture.(Like the shape of a boat
Step 2: Finishing the Base
Take a piece of cardboard and attach it to the bottom of the base as shown in the picture
Step 3: Making the Ship's Symbol
Take 3 pieces of cardboard and cut them into similar shapes as shown in the pictures and glue them one on top of another, to make a 3D shape
Step 4: Making the Ship's Decks
Take no 3,4,5 and 6 and glue them one on top of another,This is set 1
Take no 1 and glue it on one end of Set 1( this is the top of the ship)
Take no 2 and glue it on the other end of Set 1(this is the back of the ship)
NOW ALL OF THIS IS SET A
and stick all of this on the ship
I'm sorry the picture is too small
if you want a bigger picture just give me your email ID in the comments section and I will email the picture to you
Step 5: Finishing the Decks
Take no 7 and fold the edges to make a kind of dome shape
Then take no 10 and 11 and stick them together to make a similar shape to the picture
And stick it onto the front part of the ship
Step 6: Finishing the Decks Completely
Take no 1 as shown in picture and stick no 2 on the other side and no 3 on the top to make a similar shape as shown on the picture.
Now stick this pnto the back of the ship
Step 7: Sub Decks
Take 4 pieces of cardboard and cut them into siimilar shapes and all four of them should be a bit bigger than each other
1<2<3<4(if you label the diagram 1-4 from left to right
Then stick them together and glue them as shown in the picture
Step 8: Making the Edges of the Ship
Make upto 12 of these cardboard strips and stick them on the edges of the boat as sown in the picture.
Step 9: Finishing the Modeling of the Ship
Take your ship's symbol and stick it on the front of the ship
and take some paper and roll it into a tube and stick it anywhere you want(these are the smoke outlets of the ship.
Step 10: Getting Ready to Paint
Take your tape and stick it on to the sponge that you can see as shown in the pictures from picture 1 to picture 2.
Step 11: Painting and Adding Details
Paint the whole thing in white and draw small windows and doors with black markers.
Step 12: Making the Base
Take cardboard and cut them into shape
Then take tissue paper and make a big ball out of it and stick it somewhere on the piece of cardboard. and make small balls of tissue and stick many of them on the piece of cardboard
Then cover the whole thing in tissue paper
and paint it however you like but the water must stay blue and the big rock brownish.
Step 13: Finishing the Project
Take your ship and then place it on the rock as shown in the picture and hot glue it .
And you are done!!!