Custom Designed Seven Segment Using LED's | Arduino

Introduction: Custom Designed Seven Segment Using LED's | Arduino

About: i am electronic Hobbyist. I like to make the things and also make it available to people who need it. Please visit and subscribe my youtube channel for more Embedded related videos. https://www.youtube.com/c...

In this article we will see how to make custom 7 segment display using smd LED's. and We will be interfacing with Arduino.
This design can be use in the replacement of seven segement display and this is design is very cost efficient too.

In this project i have used 2 led's for one segment of the seven segment but this can done with single led and for smaller display.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Required Components

LED

Current Limiting resistor (220R) x 7

Arduino Nano board

Few Wires

As i said earlier i am using 2 led's per segment and there are 7 segments in one 7 segment. So total number of LED's will be (2x7) for single seven segment and +1 for dp (Decimal point).
And again this count will be multiply by required number of seven segment display.

Step 2: Schematic

Step 3: PCB Pics

Step 4: Code

Step 5: Tutorial and Demo

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    Discussions