DIY Hoodie Buddie

15,133

10

1

Introduction: DIY Hoodie Buddie

Instead of shelling out 30-50 dollars on a "Hoodie Buddie". You can make your own for free, granted that you have some headphones and a hoodie. This is better than the retail ones because you can change the headphones any time you want.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Materials

You will need
- a Hoodie
- Some headphones
- A scissors
- A pen/ sharpie

Step 2: Cut the Holes

Put on your hood and mark where your ears are. After this go and cut out those marks on The First Layer only, Do not cut through the entire hood. After that cut a hole near the bottom of the hood. Cut a hole in one of the pockets so you can feed the headphone jack through.

Step 3: Feed Headphones to Your Hood

Pop your ear bud into the hole you made at the bottom of the hood. You need to feed the bud up to the hole you made by your ears. After you are done repeat this step on the other side

Step 4: Put the Jack in Your Pocket

Slip the headphone jack in your pocket through the hole you made.

Step 5: Zip It Up and Jam Out

Now all you need to do is adjust the cord so it fits comfortably then plug your ipod into the headphone jack in your pocket and jam out! You can remove/replace the headphones whenever you like, just be sure you take them out before you wash them.

Be the First to Share

    Recommendations

    • Indoor Plants Challenge

      Indoor Plants Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Sculpting Challenge

      Sculpting Challenge

    Discussions