DIY LED Flashlight

Intro: DIY LED Flashlight

Easy make Flashlight

Step 1:

Step 2: Drill Holes

drill holes to switch and LED

Step 3: Solder and Glue

solder LED + to batery pack +, LED - to switch and switch to batery pack -. Glue it.

Step 4: Try It!

Take batery pack and try your flashlight

Step 5: Glue It!

Glue batery case to LED!

Enjoy!

Share

    Recommendations

    • Audio Contest 2018

      Audio Contest 2018
    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge
    • Plastics Contest

      Plastics Contest

    8 Discussions

    0
    None
    KROKKENOSTER

    3 years ago on Introduction

    I made a similar torch but I stuck a 100 ohm resistor in series with the led and it stopped the blowing up of led

    1 reply
    0
    None
    BenadskiKROKKENOSTER

    Reply 5 months ago

    With an actual LED you should, this is a small incandescent light bulb that looks a bit like one. But still a nice result! :)