Introduction: DIY Laptop Cooler (grill Like)
Easy way to do a laptop cooler. :)
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Materials / Tools
-Thread Cone (Available on any tailoring shop)
-Small on/off switch
-Small hobby motor
-9 Volts Battery
-9 volts clip
-Propeller (Any kind of elesi fan that you have)
Step 2: Solder the Wires of the Switch, Battery Clip and Hobby Motor
So that they will be all connected. The hobby motor will hold the propeller.
Step 3: Cut the Thread Cone
Cut it for 2 inch.
Step 4: Cut a Hole in the Plywood.
Put the hobby motor on the hole so that it wont move
Step 5: Put the Thread Cone on the Plywood
Use mighty bond (or super glue) so the thread cone won't move
Step 6: Tape the Wire
Tape them so that it won't look bad and messy
Step 7: And It's Done!
Hope you like it!.