Introduction: DIY Origami Paper Water Bomb
Let's make a paper bomb!
Square sheet of paper
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Fold
Fold the bottom corner up to create a triangle.
Unfold it and do the same thing to the other corners, open it up again and you'll see a x in the middle.
Then fold it in half.
Step 2: Flaps
Now that it is in half take 2 sides and fold them down.
Then unfold them.
Step 3: Tucking
Hold on to the side and open them and tuck them in
Step 4: Folds
Take the corners and fold them up to the top, do that on both sides, this would create a triangle.
Step 5: Sides
Take the sides and fold them to the center. Do that on both sides.
Step 6: Tucking
First take the top points and fold them down, then Take the top pointy flaps and tuck them in the triangle pockets. Do that on both sides
Step 7: Blowing
Then you see at one end of the top, there is a hole. Carefully hold it and blow in it. Then it will pop up like this.
Step 8: DONE!
You are done your water bomb! You can actually fill it with water! If no you can just leave it like this, when you fill it with water and throw it, it will pop and spatter water! Be careful who you toss or throw this at! Have fun!!
Follow and favorite! Comment!! Send me pictures of yours! :D