DIY PCB Drill

24,418

42

12

In this instructable I am going to show you how to make simple pcb drill out of household materials.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Materials

You will need:
soldering iron
old pen
some wires
motor
super glue
drill 0.5-1mm

Step 2:

Disassemble the old pen that you have and use this part.

Step 3:

Put a little super glue on the part that you took from the pencil on the motor and then insert the motor shaft. It should fit tightly, if it does not, roll a little paper on the motor's shaft.

Step 4:


Then solder the wires to motor.

Step 5:

Insert the drill into the part of pen and glue it.Drill must be around 0.5mm or larger.

Hack It! Challenge

Participated in the
Hack It! Challenge

Share

    Recommendations

    • Indoor Lighting Contest

      Indoor Lighting Contest
    • Make It Fly Challenge

      Make It Fly Challenge
    • Growing Beyond Earth Maker Contest

      Growing Beyond Earth Maker Contest

    12 Discussions

    0
    None
    UtkarshVerma

    2 years ago

    For those who are still struggling with it, try my instructable:
    https://www.instructables.com/id/Handheld-PCB-Drill/

    0
    None
    El-ninoR

    3 years ago

    The bit never glues perfect straight... So i cant make a hole

    0
    None
    bman46

    4 years ago

    Does it work well?

    0
    None
    john1a

    5 years ago on Introduction

    IS it sufficient for a low budget CNC mill? It looks better than embedding a (costly) dremel in a CNC build!