DIY Remote Control Holder

Intro: DIY Remote Control Holder

Tired of seeing all those remotes scattered all over the place...I wanted something stylish that could hold my remotes, glasses and a few other things...

Step 1:

So, I found a cardboard round box in my craft room and cut it a few inches to accommodate all the remotes, and some craft Arabesque printed burlap, a glue gun and went to work...

Step 2:

Cut the fabric, glue gunned it and 15 minutes later...Voila!...

Share

    Recommendations

    • Side Dishes Challenge

      Side Dishes Challenge
    • Halloween Contest 2018

      Halloween Contest 2018
    • Optics Contest

      Optics Contest

    Discussions

    0
    None

    This is much better than leaving them cluttering up the table top.