Introduction: DIY Simple Flame Following Robot Without Microcontroller
This is a Fun to do robot. The robot start to move if the sensor detects flame, be cautious when using a lighter or other element using for flame.
Required Components :
1x Castor Wheel
2x Gear Motors
1x Flame sensor
1x ULN2003 IC
1x 9v battery
1x battery snap
1x Breadboard and connecting wiresSpacers, stud, screws and screw driver
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Circuit Diagram
How to connect the components.