DIY Smart Dustbin With Arduino

1,861

10

Here we will make a Smart Dustbin by using arduino and ultrasonic sensor.
I hope you guys enjoy learning this project.

Supplies:

Arduino Uno
Ultrasonic Sensor
Servo Motor
Dustbin

Step 1: Preparing the Opening

Take a plastic sheet and cut fraw a circle with the help of dustbin and but it off from plastic sheet and then cut the circle in half and join them again with the help of scotch tape or plastic tape.

Step 2: Place the Ultra Sonic Sensor

Place the ultra sonic sensor in the dustbin as shown in the picture and move on to the next step.

Step 3: Programming

Connect the arduino and upload the given program on your arduino uno and place the arduino in the dustbin with the help of double tape and move on to the next step.

Step 4: Wiring

Now Place the 9 Volt Battery and Wire the circuit as shown in the picture above and then move on to the next step.

Step 5: Place the Plastic Circle

Now Place the Plastic circle that we had cut in the second step and and glue the half circle on the dustbin and take the servo motor and place it on the circle with fix it with the help of some glue as shown in the pictures.

Take a string and a metal Washer and tie a not with the string as shown in the picture and make an hole and pass it through the plastic circle and again tie a not with servo motor.

Step 6: Wiring the Servo Motor Final Task

Now Wire the Servo Motor according to the given Diagram and you have complete the project.

Hope you enjoy making it have some difficulties watch the video here : https://userstube.com/music/video/251/diy-make-a-smart-dustbin-at-home

Sensors Contest

This is an entry in the
Sensors Contest

Share

    Recommendations

    • Stone Concrete and Cement Contest

      Stone Concrete and Cement Contest
    • Growing Beyond Earth Maker Contest

      Growing Beyond Earth Maker Contest
    • Planter Challenge

      Planter Challenge

    Discussions