DIY Universal Tablet HandleGrip

6,597

30

4

Introduction: DIY Universal Tablet HandleGrip

Inspired by the Padlette and the HelloStrap, I wanted to make my own handle for a good grip on my tablet.
This one is intended to be cheap, really easy to make and adjustable to any device.

What you'll need:
  - A 30cm (12inches) long piece of nylon strap ; maybe more for biggest tablets, mine is 9,4"
  - 2 strap buckles
  - 2 rubber toric joints diameter 4cm (1.6 inches) (the use of flat joints might be a better choice though)

That's all folks!

ps: Sorry for bad spelling/grammar/vocabulary but english's not my mothertongue. I could add steps and instructions to make it but I thought the photos were self explanatory. 
Tell me what you think in the comments.

Be the First to Share

    Recommendations

    • Pocket-Sized Speed Challenge

      Pocket-Sized Speed Challenge
    • Audio Challenge 2020

      Audio Challenge 2020
    • Maps Challenge

      Maps Challenge

    4 Discussions

    0
    T1000
    T1000

    6 years ago on Introduction

    I made one for my Nook with Velcro One-Wrap and 2 1/8" O.D. o-rings.Thank you for the great idea!

    0
    wrokgoddess
    wrokgoddess

    7 years ago on Introduction

    Awesome.. I used duct tape once just to see if I liked the concept. I saw them on ebay once and didn't want to spend the cash.. Great idea..

    0
    FraG_s
    FraG_s

    Reply 7 years ago on Introduction

    So far, I had no problem but I see your concern and that's why I think it'd be better to use flat joints.