DODO CASE ADJUSTABLE

Introduction: DODO CASE ADJUSTABLE

1.SKI GOGGLES (STRAP, FACE PADDING)

2.CLIPS (2 MALES, 2 FEMALES)/ 3D PRINTED

3.CHRISTMAS LIGHT PACKAGING CLIPS

4.VELCRO

5. DODO CASE

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: TAKE APART GOGGLES

USE AN X-ACTO KNIFE TO TAKE THE FOAM LINER ALONG THE FACE. THEN CUT STRAPS OFF GOGGLES.

Step 2: 3D PRINT CLIPS

USE MAKERBOT 3D PRINTERS TO PRINT 2 FEMALE CLIPS AND 2 MALE CLIPS.

Step 3: ATTACH PHONE HOLDERS

USE VELCRO TO ATTACH CHRISTMAS LIGHT HOLDERS TO THE FACE OF THE DODO

Step 4: GLUE ON PADDING IN DODO CASE

Step 5: ATTACH GOGGLE STRAP/CLIPS TO DODO CASE

HOT GLUE MALE CLIPS TO THE END OF THE GOGGLE STRAP. GLUE THE FEMALE CLIP TO THE DODO CASE. NOW THE STRAPS CAN BE ATTACHED TO THE CASE.

Step 6: FINISHED PRODUCT

THE DODO CASE... A GOGGLE STRAP SO YOU CAN HAVE YOUR HANDS FREE, AND PHONE CLIPS SO YOU DON'T HAVE TO WORRY ABOUT YOUR PHONE FALLING OUT. GIVES YOU THE EFFECT OF BEING ON AN ACTUAL ROLLER COASTER.

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Raspberry Pi Contest 2020

      Raspberry Pi Contest 2020
    • Wearables Contest

      Wearables Contest

    2 Discussions

    0
    lufeng1
    lufeng1

    4 years ago on Step 2

    Do you have a link to the phone holder files for 3d printing? Thanks!