Deathly Hallows Necklace

2,946

9

3

Introduction: Deathly Hallows Necklace

I wanted to make one of these for a present, I was looking in instructables and guess what I found... there where none. Until now. If you find any spelling or grammar errors please correct me in the comments, also if you have any ideas also post those.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Supplies and Tools

1. ruler
2. solder
3. something to cut solder with

Step 2: The Base

Cut a large length of solder.

Step 3: The Cloak of Invisibility

On your length of solder measure 1 and 1 eighth of a inch and bend. From that bend measure2 and 1 fourth of a inch and bend. Then repeat the last sentence. Your solder should be in a equilateral triangle.

Step 4: Res Erection Stone

I don't know how to explain this step so try to replicate the picture.

Step 5: The Elder Wand

Bend the solder at a 90 degree angle so it goes up through the point of the triangle. Trim the end of the solder.

4th Epilog Challenge

Participated in the
4th Epilog Challenge

Be the First to Share

    Recommendations

    • Fandom Contest

      Fandom Contest
    • Jewelry Challenge

      Jewelry Challenge
    • Backyard Contest

      Backyard Contest

    3 Discussions

    0
    iskate
    iskate

    8 years ago on Introduction

    I used a nail file to make the edges not so ruff and a lot smother

    0
    dombeef
    dombeef

    8 years ago on Introduction

    Did you really look? In the related section there is one, link : https://www.instructables.com/id/Deathly-Hallows/

    And it would look better if you made it straighter and not so wavy