Desktop Aeroplane

1,101

7

1

Introduction: Desktop Aeroplane

About: Think, make, test, write, repeat

Hello everyone, i am Niko, part of RoboSap team, and today i will show you how to make simple desktop plane. It is 3D printed model of plane that fly in front of your fan or any device which blows the air.

It is very light and that therefore very cheap. It takes about 25 min to print it and 5 minutes to assemble it.

Step 1: Parts

- 3D Printed parts

  • Part 1 (1)
  • Part 2 (2)
  • Part 3 (1)
  • Part 3 (1)

- 60 cm of Fishing line (OR thread)

Step 2: Assembly

Attach Part 1 on main wing.

Step 3: Assembly

Add part 1 next to part 2.

Step 4: Assembly

Add Part 2 on wing, so Part 1 is in the middle.

Step 5: Assembly

Attach back wing on body of plane.

Step 6: Assembly

Sort out the Main parts as you can see on picture.

If parts wont stay together, you can glue them.

Step 7: Assembly

Cut 2 pieces of thread (30 cm) and wire it on plane (wire it on middle and on one of the main wings side).

Step 8: Enjoy

Make one, paste the picture of it in comets, and show us your colour combination.

Share

    Recommendations

    • Water Contest

      Water Contest
    • Fix It! Contest

      Fix It! Contest
    • Creative Misuse Contest

      Creative Misuse Contest

    Discussions

    This is such fun! It would be fun to see a variety of them in different sizes hanging out together on a fan :D