Detecting Obstacles and Warning - Arduino UNO and Ultrasonic Part 2

1,203

6

Introduction: Detecting Obstacles and Warning - Arduino UNO and Ultrasonic Part 2

About: make simple project DIY

This is tutorial to help you understand ultrasonic and buzzer and go deeper into learning Arduino, follow these steps and give me feedback

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: THINGS USED IN THIS PROJECT

1. Test Board

2. Ultrasonic sensor

3. +5V buzzer

4. Male to male pins

5. 6 LED

6.Arduino uno board Tools and materials are shown in the picture

Step 2: Connect Your Circuit

trigPin (ultrasonic) to pin 7

echoPin (ultrasonic) to pin 6

+led1 (green) to pin 13

+led2 (green) to pin 12

+led3 (yellow) to pin 11

+led4 (yellow) to pin 10

+led5 (red) to pin 9

+led6 (red) to pin 8

+buzzer to pin 3

Step 3: Load the Code to Your Arduino

Arduino Contest 2017

Participated in the
Arduino Contest 2017

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020

    Discussions