Digicam Paracord Bracelet

14,199

483

5

Intro: Digicam Paracord Bracelet

This is a paracord bracelet. This design came from TIAT's Digicam Bar. (http://www.youtube.com/watch?v=tA9dNB5sup0) I did "knot" come up with this so do not give me credit please. It is relatively easy to make. It took me about 20 minutes or so to make my first one. This is one of many Instructables I will upload on paracord bracelets.

Please vote for me in the contests. I worked hard making a Six-color Duct Tape Rose https://www.instructables.com/id/Six-Color-Duct-Tape-Rose/ that did not come close. Oh well. Maybe this can get me somewhere.

Step 1: Materials

Materials Needed:
paracord (It can be 450 or 550) To get paracord, I went to my local Army/Navy store. I buy 100ft at a time, which cost me $8 each.
I used two 5 foot cords of gold, and gray paracord to get a camo  concept.
Knife or scissors
Match or lighter to singe the ends once you are done.

Step 2: The Process

There is not much to explain. If you have had some tying experience you can get it. If you are just beginning right now it is simple. The picture explain some of the steps. I will refer to some of the pictures. Ex: Pic 1 is the First picture. You need two 5 foot lengths of paracord. Any color is fine.

Share

    Recommendations

    • Metalworking Contest

      Metalworking Contest
    • Fix It! Contest

      Fix It! Contest
    • Furniture Contest 2018

      Furniture Contest 2018

    5 Discussions

    0
    None
    JCBerry

    3 years ago on Introduction

    it looks really hard but is pretty simple. it is just a cobra and ladder knot combo

    0
    None
    moskiii13

    5 years ago

    Cool I made the same thing out of boondoggle!

    0
    None
    parabuilder

    5 years ago

    This is cool I will have to make it