Digital Pulse Generator

Introduction: Digital Pulse Generator

Digital Pulse generator is used to generate a pulse train. It generates a square wave.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Parts

For making the digital Pulse generator you will need the parts as listed below :-

  1. IC NE555 with the Stand.
  2. 10 micro farad capacitor.
  3. Resistor 2.2k ohm & 10k ohm.
  4. Variable Resistor of 100k ohm.

You can Buy these Parts from HERE !

Step 2: Circuit Diagram

Here the Astable configuration of NE555 is used. By varying the Resistance from 0 to 100k you can vary the frequency from 14.4 kHz to 687 Hz and the duty cycle (t/T) varies from 99.99 % to 52.4 %.

The LED is connected at pin no. 3 just for the indication.

Step 3: Application

Pulse generator can be used for many applications such as:-

  1. As a clock.
  2. For testing any device.
  3. As Modulation Signal.

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Arduino Contest 2020

      Arduino Contest 2020

    Discussions

    0
    BeachsideHank

    Unless I'm mistaken, there is a square superimposed over the circuit that, without differentiation, could be mistaken for circuitry wiring. If this is so, it's removal should be contemplated. Other than that, I like these quick and easy circuits.