Doesbot D1-3D Printer Assembly Tutorial

Introduction: Doesbot D1-3D Printer Assembly Tutorial

My name is Ding Qi, from Zhejiang province China. This is my first 3D printer.

Contact :http://www.doesbot.com/

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Screw Assembly

Step 2: The Bottom of the Platform Assembly

Step 3: XY-axis Platform Assembly

Step 4: Z-axis Platform Assembly

Step 5: Total Assembly

Step 6: Install Circuit Board

Switching power supply: 12V 240W
3D printer control circuit: RAMPS_1.4 http://reprap.org/wiki/RAMPS_1.4

Step 7: Stepper Motor Installation

Step 8: Installation Wind Scooper

Step 9: Installation Hot-bed

Step 10: Installation Limit Switches

Step 11: Cable Installation

Step 12: Consummation

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    6 Discussions

    0
    akanerd
    akanerd

    5 years ago on Introduction

    how much dose it cost?

    Do u have normal cnc with spindle? Cost?

    I went to Ur site but i cant read chinese.

    0
    MrE
    MrE

    5 years ago on Introduction

    You need to put INSTRUCTIONS for this to be an instructable. Other wise you have a showaffable.

    0
    onedumbtrucker
    onedumbtrucker

    5 years ago

    where is the kit from?

    0
    doesbot
    doesbot

    Reply 5 years ago

    china

    0
    doesbot
    doesbot

    5 years ago

    Yes

    0
    bpetno
    bpetno

    5 years ago

    Is this a kit?