Dog Clicker

Introduction: Dog Clicker

this dog clicker was designed to help you train your dog to do tricks.it is printed on a 3d printer using coffee colour pla.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Printing the Clicker

you can print the clicker in pla with 20% infil and 02mm layer hight.

Step 2:

to use the clicker you push the little flap up and down.you may need to use something to separate it from the other side if it get stuck.

3D Printing Contest 2016

Participated in the
3D Printing Contest 2016

Dog Challenge 2016

Participated in the
Dog Challenge 2016

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • First Time Author Contest

      First Time Author Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge

    2 Discussions

    0
    lunchweek
    lunchweek

    2 years ago

    can you please share the stl file?