In this instructable I will show you how to make a paracord dog collar. I hope you enjoy it!
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Gather Supplies
One or two colors of paracord
Dog tags with key ring
Step 2: Getting Started
Measure out how much paracord you'll need. It's basically one foot for every inch.
Then melt one end of the cords.
Next you need to melt the other ends together.
Step 3: Almost There!
Now you want to get your buckle and un buckle it.
Your gonna take the flat end of the buckle and string the cord through the top of the buckle.
Now your going to pull the cord through till you get to the middle.
Now you have a loop that your gonna put the cord through and pull tight.
Step 4: Home Stretch
Take the other end of the buckle and string the cord through the bottom.
Now you want to measure that its the right length.
Step 5: Tying the Knots
I can't really explain how to tie the knots so just look at the photos
Step 6: Next Set of Knots
So this is a king cobra. It's the same knot it's just over the first set of knots.
So just measure out how much paracord you had at first.
Now melt all the ends together.
Step 7: Adding the Dog Tags
As you continue it'll start to look like this.
This can also be a bracelet you just don't need the d-ring.
Step 8: All Done
Thank you for reading this and I hope it was helpful and that you enjoyed it and please vote on it!