Dogfish Submersible Model

Introduction: Dogfish Submersible Model

Hey everyone,

I made a 3D concept model of a submarine of my design in Autodesk Inventor Pro 2012. The idea for the submarine is inspired by small two man subs used to explore deep areas in the ocean. This model has the attached observation bell for careful study of the sea floor aided by two adjustable lamps. One thing I added to the design that I hadn't seen done before was to put a cage around the observation bell to protect it from collisions and debris. This was my first real experience with Inventor outside of doing the solid model tutorial and I learned a lot doing it. I then sent this model out for 3D FDM printing and made renders using Autodesk Showcase. I hope you enjoy the images.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Be the First to Share

    Recommendations

    • Magnets Challenge

      Magnets Challenge
    • Snow Challenge

      Snow Challenge
    • Wearables Contest

      Wearables Contest

    Discussions