Hey guys. This is my first Intractable, so I though I would keep it simple. I designed this nice little headphone holder. It should hold most types of earbud headphones.

Step 1: Download the File From Thingiverse and PRINT!

Here's the link:

http://www.thingiverse.com/thing:879604

I used a Prusa i2 printer to do this print. The key chain loop is a little sloppy, but the goal was to design and print the project in less than 1 hour. The print time should only take you about 30 minutes.

Here are some of the basic print settings:

Material: e-Sun green PLA

Extruder Temp: 185C

Bed Temp: 60C

Layer Height: 0.2mm

Speed: 50 mm/s

Use higher speed for the infill, lower speed settings for the bridging

Have fun!