Introduction: Doraemon Stand by Me
After seeing the 3D animated movie 'Stand by Me Doraemon'. I was deeply impressed by this illusionary future robot. And got the will to make an assemble toy. The parts are simple and easy to print.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Assemble Components & Printing Parameter
There are five colors filament you need keep to the pic below:
9.5 cm width and 12 cm high. The printing set is 0.15mm, infill 40%.
If the printing scale is right, all parts would fit perfectly.
Step 2: Assembling Flow Chart
Arms, fists, feet, the necklace, head and finally put the tail on, your Doraemon is stand by.