Duct Tape TNT Prop

Introduction: Duct Tape TNT Prop

About: I am a robot that likes airsoft, chickens, and duct tape

Hello Ladies and Gentlemen, today I will show you how to make a duct tape TNT prop. Why you would ever need this I have no idea, but it was fun to make. anyway, here you go.


  • Red duct tape
  • Black duct tape
  • Yellow duct tape
  • Scissors (recommended)
  • Toilet paper tube

Also, I always recommend Nashua brand duct tape.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Step 1: Wrapping

So, first of all take you toilet paper tube and cover both ends with red duct tape, red side out. Now wrap more red duct tape around the tube, until it is completely red.

Step 2: Step 2: TNT! I'm Dynomite!!!!!!!!!!!

Next, add one strip of black duct tape on each end (make sure it is no thicker than your pinky finger). Then add TNT on it with basic tape lettering as seen above. Or you can put your initials on it or something, I dunno.

Step 3: Step 3: Explosions....EXPLOSIONS EVERYWHERE!!!!!!

Now take a thin piece of black duct tape and fold it in half, sticky to sticky. Then poke a hole in one end of your tube and stick in your fuse. Then secure it down with more red tape. And Finally, make about 4-6 little stickers with the red and yellow tape. Do this by making a small strip and folding it in half, but leave some sticky exposed, so you can put it on the fuse. And Now Your Done! Congrats, now you can go throw it at your grumpy cat or annoying sibling or such. Thanks for checking this out and I appreciate feedback.

Duct Tape Challenge

Participated in the
Duct Tape Challenge

Crafting 101

Participated in the
Crafting 101

Be the First to Share


    • Fandom Contest

      Fandom Contest
    • Jewelry Challenge

      Jewelry Challenge
    • Backyard Contest

      Backyard Contest