EV3 Robot - Go Getter Bot

Fort Hays State Robotics Camp 2016

This is the robot you will build to perform certain tasks and challenges.

Step 1: Main Body

Step 2: Left Wheel "Motor B"

Axle = #8 (8 holes long)

Step 3: Right Wheel "Motor C"

Axle = #8 (8 holes long)

Step 4: Attach Front Wheels to the Body

Step 5: Rear Pivot Wheel

Step 6: Front Fastening Points for the "Brick"

Part 1

Step 7: Front Fastening Points for the "Brick"

part 2

Step 8: Rear Stability

Step 9: Rear Fastening Points for the "Brick"

Part 1

Step 10: Rear Fastening Points for "Brick"

Part 2

Step 11: Attach the "EV3 Brick"

Step 12: I-phone Holder (right Side)

Part 1

Step 13: I-Phone Holder Cont.

Part 2

Step 14: I-Phone Holder (left Side)

Part 1

Step 15: I-Phone Holder Cont.

Part 2

Step 16: I-Phone Holder Front

Step 17: Gripper Assembly

light Gray Axle = #5

Black Axle = #6

dark Gray = #8 (with flat stopper on one end)

Step 18: Gripper - Right Hook

Part 1

Step 19: Gripper - Right Hook

Part 2

Step 20: Gripper - Left Hook

part 1

Step 21: Gripper - Left Hook

Part 2

Step 22: Gripper - Motor

Part 1

Step 23: Gripper - Motor

Part 2

Step 24: Gripper - Motor

Part 3

Step 25: Output Wires (Tuck Wires Through Robot Body)

Motor B (left wheel) -short wire

Motor C (right wheel) -short wire

Motor D (gripper) -longer wire

Step 26: Front Bumper for Sensors

Part 1

Step 27: Front Bumper for Sensors

Part 2

Step 28: Touch Sensor

Input port (#1)

Sensor will point forward

Step 29: Light/Color Sensor

Input port (#3)

Step 30: Go Get'r Bot

final assembly - LCD screen should be at the rear of the Bot

Detach motor to add front Sensors - (2 bottom "red" handle connectors)