Hello! This is my first instructable. Be harsh if you have to :D. I have been informed by mrmath that these are illegal in some areas. Please check your local laws and use responsibly.
I'll be showing you how to make very easy and virtually free nun chucks made from simple materials you can find around the house.
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: The Materials
Sorry! forgot to get a picture of them :|
You will be needing the following....
-Rope ( about 2 ft. Your choice )
-A large stick. About 1 inch in diameter. ( or 2.54 cm, whatever you wanna call it :P )
- ( optional ) Electrical tape for a grip.
- And a drill
Step 2: The Saw!
You will want to get a stick that is at least 2 feet long. Cut it in half.
Step 3: Drilling!
You will want to drill a hole about an inch from the top of your wooden rods. Drill all the way through and make the hole big enough so u can fit your rope through.
Step 4: Rope!
now its time to put the rope through. First make one knot about 2 inches from the end of the rope. Then slide the stick on and tie the rest of the rope to form another knot so the rod will not slip off. Repeat for the other side.
Step 5: Yay! You're Done!
Finished :D! Now go whack something.... Not your family, friends, pets, or any other living things. I am not responsible for any injuries that may occur during the use of these nun chucks. I used my nun chucks on a soda can. look at the picture below ( it's from one single blow :D )