CNC - Electronic Board Tester

1,920

10

Introduction: CNC - Electronic Board Tester

About: Hello, I'm working at large scale high-tech company. As part of my responsibility, I provide professional support for most electrical & electronic development activities in the company: • Planning, impleme...

In the electronics industry sometimes is necessary
to test a small quantity of prototype boards.
I made this jig as electronic board functionality tester.
The top plate composed of black delrin sheet, 6mm thickness.
The delrin was used as insulation plate for an electronic board.
The surface was done according to the tested board.
The bottom part is aluminum enclosure, that including
connectors, wires, comm adapters and providing of fixity for the tester.
The shapes of all parts were drawn in Dr.Engrave S/W (provided by Roland).
The milling work was performed on Roland EGX-350 CNC machine.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Portable Workstations Contest

Participated in the
Portable Workstations Contest

Be the First to Share

    Recommendations

    • Sculpting Challenge

      Sculpting Challenge
    • 3D Printed Contest

      3D Printed Contest
    • Motor Vehicle Contest

      Motor Vehicle Contest

    Discussions