Electronic Dice

2,185

42

3

Hello everybody,

We are two students engineering from Belgium, and today, will show you how to make an electronic dice. This comes in very handy when you're playing a board game like monopoly. You will never have to worry again about letting your dices fall on the ground! Just press the button and go!

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Buy the Components

The components you'll need:

*Some Perfboard

*9x LEDs

*3x 220 Ohm resistors

*1x 10k Ohm resistor

*1x Pushbutton

*1x Atmel 2313 +Socket

*Some wire

Also needed:

Soldering tools

Arduino (for programming the chip)

Breadboard an some jumper wires (for testing)

Step 2: Make Sure You Can Program an Atmel 2313 Chip

For this step, watch this Instructables, it's really good!

https://www.instructables.com/id/How-to-Program-ATt...

Step 3: Upload the Program

Use the things you learned from the link in the previous step to upload the arduino sketch to your atmel 2313:

Step 4: Make Everything on a Breadboard

This is the schedule of the dice. It is recommended to test this on a breadboard first.

Step 5: Solder Everything on Perfboard

Solder the schedule to a perfboard.

Step 6: And You're Done!

This was the instructable. We hope you'll have tons of fun with it!

Greetings from Belgium

Be the First to Share

    Recommendations

    • CNC Contest

      CNC Contest
    • Make it Move

      Make it Move
    • Teacher Contest

      Teacher Contest

    3 Discussions

    0
    None
    pityukecske

    3 years ago

    that's how you waste 2 red leds :P

    0
    None
    JhonDee

    3 years ago

    Buen trabajo chicos.