Elephant Fusion 360

Introduction: Elephant Fusion 360

The project I chose is a elephant. The reason why I chose this is because elephants are in danger and I saw a model of an elephant on a website and I thought it would be cool. It wasn't that hard but I don't think it's for beginners.

Step 1: First Steps

First you do the body of the elephant. Next you add the head with the trunk. After that you Extrude the body and the head but not the trunk. When you do the trunk extrude it.

Step 2: Step 2: Middle

First you add lines to the bottom of the head and extrude it down. Next you add extrude the eyes on both sides. Lastly you make the ears but first you have too make a line between the head and the body. Then you extrude the ears up.

Step 3: Step 3: Lastly

First you add lines in the trunk. Then you extrude it down .10. At the back you smoothin it out.

Be the First to Share

    Recommendations

    • Pocket-Sized Speed Challenge

      Pocket-Sized Speed Challenge
    • Super-Size Speed Challenge

      Super-Size Speed Challenge
    • Metalworking Contest

      Metalworking Contest

    Discussions

    0
    audreyobscura
    audreyobscura

    1 year ago

    Thanks for showing how you designed this elephant!