Introduction: Emergency Light by Junk

By

in this INSTRUCTABLES I WILL SHOW YOU HOW I RECREATE THIS EMERGENCY LIGHT

I FOUND THIS IN JUNK OF MY NEIGBHOUR

AND SOMEBODY SAID SOMEONE JUNK IS SOMEONE TREASURE AND FOR US ITS TRASURE

SORRY ABOUT MY ENGLISH BECAUSE I AM ONLY 13 AND STUDY IN 8th CLASS

SO WITHOUT FURTHER LETTTTTTTTTTTTTTTTTTTTTSSSSSSSSSSSSSSSSSSSSS!!!!

DOOOOOOOOOO THISSSSSSSSSSSS!!!!!!!!!!!!!!!!!!!!!!!

Step 1: PARTS NEEDED

PARTS YOU GONNA NEED ITS UNDER 2$ ONLY FOR ME

ONE BROKEN ON DAMAGE EMERGENCY LIGHT-FREE

ONE 1K RESISTANCE

ONE 606 TRANSFORMER

ONE 10K POT

ONE TOGGLE SWITCH

ONE M-SPEAL

ONE RED LED

THREE 1N4007 DIODES

TOOLS

SCREW DRIVER

WIRE OPENER

CUTTER

SANDER AND SAND PAPER

GLUE

PAINT

HOT GLUE

Step 2: OPENING IT

SIMPLY JUST OPEN IT AND CUT OUT THE WIRES

Step 3: Harvest the Parts

you gonna harvest the parts like i did

Step 4: Repair the Body

you gonna use mspeal AND APPLY TO THE BURNED BODY

NOTE-AFTER APPLYING IT OPEN IT OTHERWISE IT WILL HARDER AND YOU CAN'T PUT THE PARTS IN

Step 5: MAKING THE CHARGING INDICATOR

YOU WILL NEED ONE RED LED

ONE 1K RESISTANCE

ONE DIODE 1N4007

AND CONNECT THEM AS SHOWN IN THE SCHEMATIC

Step 6: CHARGING CIRCUIT

PARTS YOU WILL NEED

606 TRANSFORMER

2-1N4007 DIODES

1-AC INPUT CIRCUIT

1-CHARGING INDICATOR

CONNECT THEM AS THE SCHEMATIC

Step 7: WE ARE DONE

PARTS YOU GONNA NEED

1-CHARGING CIRCUIT

1-4V 1.5A BATTERY

1-TOGGLE SWITCH

1-10K POT

1-LED BOARD

AND CONNECT THEM AS THE SCHEMATIC

AND PUT IT ALL TOGETHER