Enables DIY Display Booth

Introduction: Enables DIY Display Booth

A quick guide on purchasing and assembling Enable's Display Booth.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Step 1: Shop for Hardware

Get the necessary supplies form your local hardware provider.

Step 2: Step 2: Cut the Pipes

Cut all four of the 10'-0" pvc pipes in half. You will end up with eight 5'-0" lengths.

Take two of the 5'-0" lengths you just cut and cut them in half. You will end up with four 2'-6" lengths.

Home Depot will cut these for you when purchasing in the store.

Step 3: Step 3" Layout Your Pieces

Layout your pieces as shown.We will assemble the three main areas:

  • Top
  • Legs
  • Feet

Step 4: Step 4: Assemble Top

Assemble the top as shown using:

  • 2 Elbows
  • 2 PVC Pipes 5'-0"
  • 1 Coupler

Step 5: Step 5: Assemble Legs

Assemble the Legs

Step 6: Step 6: Assemble Feet

Place one elbow onto each of the 2'-6" pipes. Connect the other ends to the PVC Tee.

Step 7: Step 7: Put It All Together

Put everything together:

  • Top to Legs
  • Legs to Feet
  • Attach banner to Top

Stand up the display. If you haven't already turn the feet outward (90°) at the Tee creating a stable base.

NOTE: I recommend not tightening the joints between the legs and the feet (Tee) until after the display is upright.

Be the First to Share

    Recommendations

    • Backyard Contest

      Backyard Contest
    • Silly Hats Speed Challenge

      Silly Hats Speed Challenge
    • Finish It Already Speed Challenge

      Finish It Already Speed Challenge

    Discussions

    0
    seamster
    seamster

    5 years ago on Introduction

    Great guide! Thank you for putting this together and sharing it here.