Engraved Rock!

Introduction: Engraved Rock!

There is not very many steps to this project. I will have a lot more explanations.

Step 1: Engraving

To start out with anything. You will need a tape measure. You will use this to measure the rock so you can make the file to engrave the rock. Once the file is made for the rock to be engraved, you will place the rock into the laser bed. Make sure the head of the laser is exactly the same spot you have on the file. Once this is lined up, you are ready to start engraving the rock.

Makerspace Contest

Participated in the
Makerspace Contest

Be the First to Share

    Recommendations

    • Mason Jar Speed Challenge

      Mason Jar Speed Challenge
    • Bikes Challenge

      Bikes Challenge
    • Remix Contest

      Remix Contest

    Discussions

    0
    jkimball
    jkimball

    4 years ago

    Speed, power, and make/model of the laser you used might be a nice start...