Experiment 4 Serial Port Communication

The components used in this experiment are shown below:

The experiment needs only the Arduino board.

Step 1: Wire Diagram

Plug the Arduino to PC  through the USB port.

Step 2: Arduino Code

void setup() {
Serial.begin(9600);
}
void loop() {
Serial.println(“Hello World!”);
delay(1000);
}
Observe the output using a serial terminal console.

Share

    Recommendations

    • Optics Contest

      Optics Contest
    • Plastics Contest

      Plastics Contest
    • Make it Glow Contest 2018

      Make it Glow Contest 2018

    Discussions

    0
    None
    dahmaneh

    2 years ago

    very good