Extendable Arm

Have you ever wanted to grab something out of your reach, yet, are too lazy to get up? Well now you can by 3D printing this device.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Printing

To print, you just have to download the file above and send it to your printer via SD card or flash drive.

Step 2: Setup

To put the device together, you will see the two rods that you must snap together. Slide the pegs into the slots on the cylinder and then screw the cylinder into place.

Be the First to Share

    Recommendations

    • Book Character Costume Challenge

      Book Character Costume Challenge
    • Made with Math Contest

      Made with Math Contest
    • Cardboard Speed Challenge

      Cardboard Speed Challenge

    Discussions

    None
    Swansong

    2 years ago

    Those are fun :)