You will need for this project
- 1x Arduino Uno
- 1x Potentiometer
- 5x 220ohm Resistors
- x5 LEDs
- Handful of jumper wires
Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.
Step 1: Get Your Components Like So
Step 2: Potentiometer
First, go ahead and connect your potentiometer to the ground and power row on the bread board, and the digital cable to analog 0 pin
Step 3: LEDs
Line your LEDS up in a straight row like so
Step 4: Ground LEDs
Ground the LEDs to the row below to the breadboard, next to each LED, place your resistors