Intro: Fidget Ring. Small Wearable Fidget Toys
Hey, Its me Balsuryana. Its so long time i'm not write something about DIY or tutorial, Because so many works i need to complete. Now i'm back again!!!.
In this article, i will show you something very interisting projects. I made a Fidget Ring or Fidget toys with ring shape. This is a very easy projects. This is not only easy project but this is Awesome Project. You can use this ring indoor / outdoor because the design is very stylish and simple.
OK, Lets make it!
Step 1: Materials and Tools
- a Tactile Switch
- 1/2 Inch pipe (You can use bigger pipe.(It depends your finger))
- Super Glue
- Pen / Marker
Ok, we get all the materials, now Lets make it.
Step 2: Cut the Pipe
- First, place the Tactile switch to the end of the pipe
- Take your pen and make a mark and draw a straight line like image 3
- Cut the pipe using the knife
- After you finish cut the pipe, now you need to cut the one side of the pipe
- Make it like image 7
Step 3: Make the Ring Clean
Haaa, This ring is Almost Finish!!. Before we going to the next steps, we need to clean the ring. Take the sandpaper and make the ring smooth and clean.
*Make sure no sharp edges on the ring, because it will hurt your finger if you use it...
Step 4: Final Step
Take the tactile switch and place it on the top of the ring. Next, use the pliers to bend the tactile switch foot (it will looks like image 2). After that, apply the super glue to the tactile switch and wait it until dry.
Step 5: Finish
Thats it!!. Your cool Jewellery is ready to use.
This Ring can used for Male or Female because the design is simple stylish.
How to use this?
Use like you use an ordinary ring, and if you bored or fidget, you just click the switch and your problem is go away!.
Thanks for look my works!
Don't forget to like this and follow me if you like my projects...