Fidget Toy 102

Introduction: Fidget Toy 102

Super simple Diy toy, this is the second version of my fidget toy. I have narrowed it down to 4 parts, the bearing, two hole plugs and a pipe clamp.

Teacher Notes

Teachers! Did you use this instructable in your classroom?
Add a Teacher Note to share how you incorporated it into your lesson.

Step 1: Assembly

It is pretty stain forward what needs to be done. first put the plugs in the bearing inner bore. Next place the bearing in the clap and tighten the screws.

Step 2:

Boom done!! see how complicated that was. the whole thing cost me about $3.50 but I did not purchase the bearing. the bearing alone is about $15, but that's still under $20. I had fun with this project and I hope I have given some people some good ideas.

Be the First to Share

    Recommendations

    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Rope & String Speed Challenge

      Rope & String Speed Challenge
    • Wearables Contest

      Wearables Contest

    3 Discussions

    0
    TaikiS
    TaikiS

    2 years ago

    what type of bearing did you use (dark work, bonez red, abec 7, etc...) you should also post a video of the outcome...

    0
    EthanK15
    EthanK15

    3 years ago

    where would i get to caps just from like a hardware store and the are the caps nessasry

    0
    Kilroy95
    Kilroy95

    Reply 3 years ago

    the caps are not completely necessary I put them on because you can get a better grip. I got mine from Ace hardware, they were like $0.89 a piece.