Flower Pot Stand

I wanted to make Indoor Flower pot Stand from the scrap
wooden baton strips  of 40 mm width and 5 mm thick strips

1) I cut these strips of 400 mm length- 12 No's ( White strips as seen in snap -2 )
     and 220 mm length strips-4 No's ( Black strips as seen in snap -2 )
2) Nailed 3 White strips parallel at there center on the Black strips with a gap of 25 mm
      Made such 4 assembly's as seen in snap-3
3)  Now all the 4 assembly's White strips are nailed on the edges at all 4 corners
      to form a square of 400 mm length as seen in snap-4
4)  Now We can put Indoor Pot inside this square Stand

It is simple,cheap and looks beautiful !