Fun Jewelry

Intro: Fun Jewelry

I am an industrial design student helping a young jewel designer on a new and fun way to create jewels!

Modeling tools: Solidworks and Cinema 4D

Plastic: PLA

Step 1: Modeling

After looking up for the common dimensions in the jewelry world...don't think about it anymore! Except for the dimensions of the holes where you will put a chain, let go your imagination!

In my case, I have been looking for simple shapes that recreate funny product at another scale!

Step 2: Finishing

In this case, the resolution is not top of our expectation ...a little bit of sanding is necessary! After that, let's put varnish and color if needed.

Enjoy!

Share

    Recommendations

    • Plastics Contest

      Plastics Contest
    • Electronics Tips & Tricks Challenge

      Electronics Tips & Tricks Challenge
    • Audio Contest 2018

      Audio Contest 2018

    Discussions

    0
    None
    tomatoskins

    3 years ago on Introduction

    This is awesome! You should share the .STL so others can print it as well.